The two-shot injection moulding process combines two different materials in a single automated cycle that can also include colouring. This results in highly functional components with specifically combined properties – such as hardness and elasticity, transparency and strength, or media resistance and flexibility. Common use-cases include silicone with thermoplastic, silicone metal combinations, or silicone components made from different Shore hardnesses. Hard-soft combinations with TPE are also among the frequently used material pairings. The materials are injected sequentially or simultaneously into a specially designed mould and subsequently form a permanent bond – mechanically, chemically, or thermally anchored. Compared to the single-component process, two-shot injection moulding reduces the risk of assembly errors – a crucial advantage in complex components.

Our plastic bowls in two different sizes and the designer ISO2go cup are the perfect companions for your modern lifestyle. Whether for your daily meal on the go or your morning coffee - with our products you are well equipped. Invest in products that are not only good for you, but also good for the environment. Experience the perfect mix of comfort and design - every day, everywhere.

Our thermoplastic and LSR injection moulding methodologies also facilitate the creation of multi-component parts, i.e. hard/soft, hard/hard or soft/soft combinations involving two or three different materials.

In diesem Bauteil werden mehrere Funktionen in einer Hybridlösung integriert. Elektrische Verbindung zwischen Kabel und Batterieschuh mit einer elektrischen Isolation zur Umgebung und einer Abdichtung gegen eindringende Feuchtigkeit. Aufgrund der Position und Geometrie der Dichtbereiche wird ein Werkzeugkonzept mit Indexplattentechnologie eingesetzt, was in Bezug auf Toleranzausgleich einen erhöhten Schwierigkeitsgrad darstellt.

Innovative electronic position indicator consisting of 3 housing components, some of which are made of several materials: Front housing: 1) PA66 CF30; 2) PA6 (disk); 3) TPV+batch (blue buttons) Rear housing: 1) PA66 CF30; 2) TPV (seal) Drive shaft: POM Harmony with each other, as well as with the married metal and electronic components, is essential.

3-D MID (Mechatronic Integrated Devices - three-dimensional circuit carrier) enable to reduce weight, size and the number of components of a three-dimensional electronic part and can include mechanical, electrical and fluidic functions. The picture shows the productions steps of a LED element for medical devices.